Machining new rails at 60 km/h on Sofia's new metro line

Before the new No. 3 metro line in Sofia went into operation in late August of 2020, Vossloh gave the newly-laid rails an initial grinding to prepare them for service. Removing the factory mill-scale not only extends a rail's service life considerably, it also lays the foundation for preventive rail maintenance.

To ensure a long rail service life, the important new rail maintenance was carried out shortly before the opening of the first section of Metro Line 3.

Over eight nightshifts in August of 2020 Vossloh successfully machined all the new rails of the recently laid, almost 8-km-long subsection of the new No. 3 metro line. This "green line" connects eight stations from Krasno Selo in the Bulgarian capital's south-west to Hadzhi Dimitar in the north-east and has two transfer stations for passengers to change to lines already in service. The 3.8-km-long extension west of Krasno Selo to Gorna Banya was also ground in anticipation of the second subsection's commissioning in early 2021.

Ensuring the rails have a long service life
Removing the comparatively soft external decarburized layer left over from the manufacturing process provides the basis for ensuring the rail has a long service life. Studies and research programs on the effects of mill-scale and decarburization prove that removing this layer reduces not only wear but also the formation and spread of fatigue damage caused by wheel-rail contact (e.g. head checks). Over the long term, this translates into enormous savings in time and money for the operator.

The order called for the removal of 0.2 mm of material. Grinding wheels with two different grain sizes were used to grind the newly-laid rails: first a rough abrasive to remove material and then a fine abrasive in order to achieve a surface finish that although smooth still has the appropriate rail roughness to keep noise emissions low. The technology of a high feed rate and passively driven grinding wheels always results in a rail surface that is free of facets, corrugations, periodic grinding marks or "bluing".

The swiveling grinding units re-profiled the rail head to exactly z-12. These units are also compliant with track installations such as level crossings or electronic switching equipment, which consequently do not require removal before the rails can be machined. There was also no grinding residue left on the track to collect and therefore no subsequent clean-up necessary.

The machining of the new rails coincided with the test runs of the new metro vehicles, and in retrospect the HSG-city's performance in Sofia can be seen as a real gain. High operating speeds of up to 60 km/h and the Vossloh team's flexibility meant that the HSG-city was able to fit in easily with "normal operations", commuting between different sections of the line in the 4 and 8-km-long tunnels.

www.vossloh.com

  Ask For More Information…